JGE ENGINEERING SDN. BHD.

JGE Engineering was proudly registered with PETRONAS for Continuous Emission Monitoring System (CEMS) & Sampling System

JGE Engineering was proudly registered with PETRONAS for Continuous Emission Monitoring System (CEMS) & Sampling System

Here is where you can write more information about your team's core value.

Here is where you can write more information about your team's core value.

Here is where you can write more information about your team's core value.

Here is where you can write more information about your team's core value.

Here is where you can write more information about your team's core value.

Here is where you can write more information about your team's core value.

We provide turnkey solution to CEMS application ranging from Power Plant, Chemical Plant, Refineries to Waste Incinerator.Our One Stop Solution includes Registration with DOE, Engineering, Installation, Commissioning, Data link with DOE and QA/QC of the CEMS.

The multi gas analyser MGA 12 serves the continuous measurement of pollutants in flue gas (e.g. CO,CO2, SO2, NO) and the measurement of O2 as well as the continuous process control.The analyser device is suitability tested according to DIN EN 15267‑3 and certified in compliance with QAL1. As a part of the analyser system MGA 12 it is suitability tested and certified for systems after “TA Luft”, 13th and 27th BImSchV according to DIN EN 15267-3.

The multi component analyser MCA 10 HWIR serves the continuous emission measurement of pollutants in flue gas (e.g. CO, NO, N2O, NO2, NH3, CH4, HCl, SO2, HF; as system additionally TOC) and the measurement of CO2, H2O and O2 as well as the continuous process control.The device is suitability tested according to DIN EN 15267‑3 and certified in compliance with QAL1 as well as MCERTS Performance Standards. As a part of the analyser system MCA 10 HWIR it is suitability tested and certified for systems after “TA Luft”, 17th and 27th BImSchV according to DIN EN 15267-3.

The dust measurement device PFM 02 V is an in-situ dust measurement in combination with the flow measuring device FMD 02 or other velocity measuring devices.The use of the triboelectric measuring principle (charge transfer at conducting surfaces) guarantees a device simply to install and handle as well as a timely monitoring of the dust emissions.

The dust concentration measuring device PFM 06 ED is used for the continuous extractive measurement of dust contents in wet and sticky exhaust gases. Measuring gas is drawn off the process and led to the measuring cell via a probe being temperature controlled. Inside of the measuring cell there is an optic measuring unit.It is suitability tested according to EN 15267-3 (QAL1)